Cheap Hosting

Our Mailing List

Random Image Plus

Google Ads

This will allow you to refit the o.e LCD display so to retrieve all the audio, Temp & Trip display features. I'm not the
first person to do this mod so thanks to them for the part numbers but decided to try and do step by step pics...Enjoy

Parts/Tools Needed:-

LCD Visor Peugeot part No:P00008209G8 cost 45.77
Hot glue gun
Dremmel
Torx T10 & T20
Soldering iron & solder
Heat shrink or electricians tape
wire
Time 1.30-3hrs

Start with removal of Radio two T10 Torx in the holes each side of radio

Image

Then the LCD/Computer display two T20 Torx as in Pic

Image

Remove the air vent panel again two T20 torx at front then gently prise panel upwards down both
sides then carefully lift the front of the panel to unclip the two clips at front, panel will lift out.

Image

Item marked in green I removed in the end just making sure panel would fit ok, the length of cut out was 87mm
at the sides from rear (panel is slightly bigger in middle) then cut a straight edge in the honeycomb panel.
Marks in RED were cut out for the clips on the LCD visor mount.
Marks in BLUE were cut out for the LCD wiring plug to feed into the display

Image

Test fit

Image
Image


Be careful when extending the wires CUT ONE WIRE at a time then solder and heat shrink

Image

Finished wire

Image

With A bit of Glue to hold the LCD in place.

Image

Finished Item

Image
Image
Image

Not a hard mod to do but well worth it when you have lost all features that come with the o.e LCD

l